Diagnostic procedure
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable.
2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness
connector with the ignition switch off.
3. Attach the tester leads to the SST and inspect voltage referring
the table below.
Terminal Voltage Table (Reference)
(Engine is idling, and co ...
Mazda 6 Service Manual: Steering gear and linkage removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...