Mazda 6 manuals

Mazda 6 Service Manual: No.24 a/c is always on or a/c compressor runs continuously

Mazda 6 Service Manual / Fuel and emission control systems / Troubleshooting / No.24 a/c is always on or a/c compressor runs continuously


Diagnostic procedure


No.23 a/c does not work sufficiently
Diagnostic procedure ...

No.25 a/c is not cut off under wide open throttle conditions
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Side protector installation
1. Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor. 2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body. 3. Attach double-sided adhesive tape to the side protector as shown (if it ...

Mazda 6 Service Manual: C-pillar trim removal/installation
4SD 1. Remove the tire house trim. 2. Turn the seaming welt over. 3. Remove the cap using a fastener remover, and remove the bolt (with curtain air bag system). 4. Disengage clips A and clip B using a fastener remover. 5. Pull the C-pillar trim forward, then disengage hook C from the body, ...

© 2016-2025 Copyright www.mazda6info.net