Mazda 6 Service Manual: Purge solenoid valve removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Vacuum Hose Installation Note
Attach the vacuum hose onto the purge solenoid valve until it contacts the stopper.
Evaporative Hose Installation Note
Attach the evaporative hose onto the purge solenoid valve until it contacts the stopper.
Evaporative gas check valve (one-way) inspection (l.h.d.)
1. Remove the evaporative gas check valve (one-way).
2. Apply pressure to port A, and verify that there is no airflow.
If there is airflow, replace the evaporative gas check valve (one-way).
3 ...
Purge solenoid valve inspection
Airflow Inspection
Note
Perform the following test only when directed.
1. Disconnect the negative battery cable.
2. Remove the purge solenoid valve. (See PURGE SOLENOID VALVE
REMOVAL/INSTAL ...
Other materials:
Mazda 6 Service Manual: Selector lever disassembly/assembly
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly.
Connector Disassembly Note
1. Insert a thin piece of metal from the terminal side of the connector, and
press down the terminal locking tab.
2. Pull the terminal out of the connector. ...
Mazda 6 Service Manual: Electric Parking Brake
The electric parking brake equipment applies the parking brake using an electric
motor. When the electric parking brake is applied, the electric parking brake switch
indicator light turns on.
WARNING
Do not drive the vehicle with the electric parking brake applied:
If the vehicle is driven ...