Mazda 6 Service Manual: Automatic transaxle shift mechanism

Drive plate removal/installation

1. Remove the transaxle.(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the figure. 3. Install in the reverse order of removal. Drive Plate Mounting Bolts Re ...

Shift-lock inspection

1. Turn the ignition switch to ON position. 2. Verify that the selector lever is in P position. 3. Depress the brake pedal and verify that the selector lever can be shifted from P position. If ...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (CLUTCH) Clutch Pipe Removal/Installation Note A common reservoir is used for the clutch and brake system fluid. 1. If clutch pipes have been disconnected any time during the procedure, add clutch fluid (brake fluid), bleed the air, and inspect for leakage after the procedure ...

Mazda 6 Service Manual: Schedule 2
    Chart symbols:   I : Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary. R : Replace L : Lubricate C : Clean T : Tighten Remarks:   *1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL ...