Mazda 6 Service Manual: Theft-deterrent system

Information display removal/installation

1. Disconnect the negative battery cable. 2. Remove the center panel module. (See CENTER PANEL MODULE REMOVAL/INSTALLATION.) 3. Remove the LCD unit. (with car-navigation system) (See LCD UNIT RE ...

Bonnet switch inspection

Note Bonnet switch has a built-in bonnet lock. 1. Open the bonnet. 2. Disconnect the negative battery cable. 3. Remove the radiator grille. 4. Disconnect the bonnet switch connector. 5. Che ...

Other materials:

Mazda 6 Service Manual: Vehicle speedometer sensor (vss) inspection
Visual Inspection 1. Remove the VSS. (See VEHICLE SPEEDOMETER SENSOR (VSS) REMOVAL/INSTALLATION.) 2. Make sure that the sensor is free of any metallic shavings or particles. If any are found on the sensor, clean them off. 3. Install the VSS. (See VEHICLE SPEEDOMETER SENSOR (VSS) REMOVAL ...

Mazda 6 Service Manual: Trailing link removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...