Mazda 6 Service Manual: Trim

Console disassembly/assembly

1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. ...

A-pillar trim removal

1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from th ...

Other materials:

Mazda 6 Service Manual: Front lower arm (rear) removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.) Front Lower Arm (Rear) Ball Joint Removal N ...

Mazda 6 Service Manual: Generator inspection
Generator Warning Light 1. Verify that the battery is fully charged. Charge if necessary. 2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION.) If not as specified, replace the drive belt. 3. Turn the ignition switch to ON and verify that the gene ...