Mazda 6 manuals

Mazda 6 Service Manual: Drive shaft

Wheel hub, hub spindle removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Joint shaft pre-inspection
1. Verify that the joint shaft is not twisted or cracked. Replace it as necessary. 2. Turn the joint shaft by hand and verify that the bearing rotates smoothly and freely. Replace it as n ...

Other materials:

Mazda 6 Service Manual: No.2 air bag system warning light is illuminated all the time
Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connec ...

Mazda 6 Service Manual: Setting the System
When the MODE switch is pressed, the Mazda Radar Cruise Control (MRCC) main indication (white) turns on and the vehicle speed and the distance between vehicles while in headway control can be set. NOTE When the ignition is switched to ACC or OFF while the Mazda Radar Cruise Control (MR ...

© 2016-2026 Copyright www.mazda6info.net