Mazda 6 Service Manual: Audio and navigation system

Immobilizer system reprogram procedure

Note When an error occurs during the reprogram procedures, except when the PCM is replaced, repeat the procedure from Step 1. If you still cannot reprogram, confirm how many keys can start t ...

Anti-theft system

Alarm Conditions If the anti-theft system protection has been activated, any one of the following conditions will trigger the system: - Disconnected battery cable - Discharged battery ...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (FRONT AND REAR AXLE) Wheel and Tire Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf} Brake Line Disconnection/Connecti ...

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection Preparation 1. Verify that the battery is fully charged. With the ignition switch on, verify that the ABS and BRAKE system warning lights goes out after 2.4 seconds. 2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM detects a failure. Follow the troubles ...